Hello, I am experiencing a strange rounding issue in regards to quality measure testing.

In production I input the correct measurement result and it is marked as a fail. The norm and tolerance is as follows:

Norm: 1.2345

Tolerance: 1.2343-1.2347

Decimal accuracy: 4

The error occurs When in the work order tablet view after entering the measurement result and validating. Inputting the exact same value as the norm - the popup states the following: "You measured 1.23 in and it should be between 1.23 and 1.23 in."

The value recorded in the quality check (QC) matches the value that was entered in the tablet view (1.2345). This is clearly wrong and I cannot find a solution for this. I hope that we can solve this issue here to help others as well as myself. Thank you.